Irritec Perma-Loc Tubing x MHT Tee Adapter
Perma-Loc Tubing x MHT Tee Adapter
This tee adapter is used to run poly irrigation tubing in two opposite directions from a FHT (female hose thread) connection. Fitting has two perma-loc tubing outlets and a standard 3/4" MHT (male hose thread) connection.
The Perma-Loc connector on this fitting is compatible with Drip Depot polyethylene tubing of the same size.
About Drip Depot Perma-Loc Drip Irrigation Fittings:
Perma-Loc fittings are heavy duty reusable connectors, adapters and fittings for all your connection needs. They are very easy to use and require no special tools. Perma-Loc fittings are available for both Tubing and Tape. The Tubing connectors can be used on blank tubing as well as drip line.
- To use: Simply push tubing or tape over barbed end, then hand-tighten locking nut over tubing or tape for a permanent secure fit.
- To Remove: Just loosen locking nut, pull tube off and re-use as needed.
Perma-Loc fittings look similar to traditional flange and locking nut plumbing connections; however, in most cases, they work differently. Unlike a typical locking nut, which comes off the fitting and slides over the tubing, a Perma-Loc locking nut is usually not removed from the fitting. The exception to this rule are some of the larger 3/4" and above tubing fittings. Select a video from above to see how the Perma-Loc drip irrigation tubing and tape fittings work.
|Perma-Loc Size||Acceptable Inside Tubing Diameter||Acceptable Wall Thickness|
|3/8 inch||.510 to .580 inches||.035 to .055 inches|
|1/2 inch||.590 to .630 inches||.025 to .050 inches|
|3/4 inch||.790 to .845 inches||.045 to .065 inches|
|1 inch||1.025 to 1.085 inches||.045 to .070 inches|